Page 2
Table of Contents 1.0 Specifications ................. .1 2.0 Symbols and Conventions .
Page 3
1 .0 Specifications The Labnet 6 Liter Water Bath is a general purpose 6 liter water bath capable of heating liquids and accurately maintaining temperatures up to 100°C. Temperature range Ambient to 100°C Controls Analog, hydraulic Chamber size (W x D x H) 13 x 6.7 x 6.9 in.
Page 4
4.3 Heating Lamp When the unit is heating, the light is ON. When the unit has reached the set point temperature, the light will only be ON when the unit is calling for heat to maintain temperature. LABNET 6 LITER WATER BATH...
Page 5
5.0 Operation WARNING: This water bath is not intended for use as an acid bath. Do not used as an acid bath as this will cause severe damage to bath components. Do not use deionized water, tap water, or chemicals. USE DISTILLED WATER ONLY. If tank boils dry while containing plasticware, the plastic will melt.
Page 6
Temperature Controller is turned up. Finally, check the fuses. Should you have a question about the Labnet 6 Liter Water Bath or require service for the unit, contact Corning Customer service at 800.492.1110 or 978.442.2200. Do not send a unit for service without first calling to obtain a repair authorization (RA) number. The unit should be properly packed to avoid damage.
Page 7
To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.
Need help?
Do you have a question about the W1106A and is the answer not in the manual?
Questions and answers