Advertisement
Regular Maintenance
The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour
meter to determine when regular servicing is required.
Refer to the Detailed Maintenance section for futher instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
ITEM
Drive Shaft Yoke, U-Joint
& Stub Shaft
Pump Drive Shaft Coupler
Crankshaft Adapter
Pivot Points
Hydraulic Fittings
Knives
Spindle mouting bolts
spindle to deck)
Knife mounting bolts
(knife to disk or blade bar)
Disk/Blade Bar mounting bolts Check
(disk/blade bar to spindle)
Belts
Main Frame and
Deck
Hydraulic Fluid Level
Rear Flail Drive(if applicable)
Bear Flange and Shaft Coupler
Cutter Shaft and
Boom
©2020 Alamo Group Inc.
MAINTENANCE
Daily or Every 8 Hours
SERVICE
Grease
Check and Lube
Check rubber grommets
Lubricate
Check for leaks
Check
Check
Check
Check/Adjust
Check
Check
Lubricate
Lubricate
Maintenance Section 4-4
COMMENTS
Grease as instructed in
detailed maintenance section
Insure driveshaft end play
Replace grommets if
damaged or missing
Inject grease until it
appears at end
Tighten when needed. Do Not use hands
to check for leaks, see maint. precautions
Inspect for missing or damaged knives,
change as needed.
Torque to 315 ft. lbs. lubricated
Torque to 357 ft. lbs. dry
Pre-lubricate threads with anti-seize
torque to 800 ft. lbs.
Torque to 180 ft. lbs. lubricated
Torque to 204 ft. lbs. dry
Check if broken, tighten as required
Retorque bolts to torque
specifications in this section
Add if required per fluid recommendations
Grease as instructed in
detailed maintenance section
Grease as instructed in
Advertisement
