Advertisement
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
GENERAL HOSE INSTALLATION
Refer to the Parts Section for detailed information about hoses and fittings for this
application.
(ASM-C-0011)
Secure hoses together with zip ties wherever loose. Wrap the hoses with the hose covers as
illustrated in the Parts Section. Where hoses may contact the frame or other edges, wrap with
split hose and secure with hose clamps or zip ties. On non-cab units the pressure and return
hoses from the control valve will also need to be routed inside the protective clear hose wrap.
(ASM-C-0019)
Install a solenoid valve on the mounting bracket with the supplied hardware as shown in the
Parts Section in this manual. While installing the fittings to the brake valve, the electrical coil on
the spool may have to be removed to make room. When reinstalling the coil, it is important to
use no more than 5 ft. lbs. (or 60in. lbs.) torque. WARNING: OVER TORQUE TO THE COIL
WILL RESULT IN HYDRAULIC FAILURE OF SPOOL.
TEMPERATURE GAUGE MOUNTING
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
With the tractor on jack-stands, remove the existing hardware and the three point links on the
rear axle where the axle braces will be mounted. Use a hoist to raise the axle braces to the
correctly matching mounting holes on the rear axle and the mainframe. Use the existing
hardware to attach the braces to the tractor. DO NOT tighten the hardware at this time. Remove
the capscrews one at a time and apply a thread locking agent. Reinsert the capscrews and
tighten / torque to values noted in the torque chart located in the Maintenance Section of this
manual. Re-attach the links to the three point hitch with the existing pins.
ASSEMBLY
(ASM-C-0056)
HOSE COVERING
SOLENOID BRAKE VALVE
AXLE BRACE INSTALLATION
Assembly Section 2-14
(ASM-C-0025)
(OPTIONAL)
(ASM-KUB-0044)
(ASM-C-0051)
Advertisement
