Limit Output Alarm Mode - Datcon DT9500 Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by the supervisor code.
Exit from the menu item
40

7.5. Limit output alarm mode

In alarm mode, the limit output is switching on when the
limit condition exist. But the output stays switched on
(independent from the limit condition) until the ENTER
button is pressed (alarm acknowledge). (All these
information are described in detail in Chapter 7.4. Setting
up the limit output No. 1.)
Chapter 7.1. Typing the code in describes how you can
type the code in. You see on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. Keep stepping by pressing the ▲ button as you see this

sub-menu item:
5. Enter by pressing the ENTER button.

6. You see this
blinking.
7. You can switch the alarm mode on by pressing the ▲
button.

•
 = the limit output will switch off automatically when
the condition that had caused it to switch on ceases to exist
[default factory setting].

•
 = switching the limit output off is possible only by
pressing the ENTER button. It stays switched on, no matter
if the condition that had caused it to switch on ceases to
exist.
1. After finishing the settings, press the MENU button to
exit from the menu item, and you see this:
2. Press the MENU button to exit from the menu item, and

you see this:
(3. If you don't want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)

.
(Alarm Mode).
on the display. The mnemonic is
.
DT9500

.

.
20220103-V2