Table of Contents
Advertisement
DT9500
Exit from the menu item 1. After finishing the settings, press the MENU button to
Exit from the menu
20220103-V2
34. You see this
L1.HH. It can be changed to any values between 00.0 and
99.9. The digit at the left side is blinking.
35. Pressing the ► button you can select the next digit.
36. Pressing the ▲ button you can increase the value of
the blinking digit:
,
,
,
,
37. After you have set the value of the hysteresis, press the
MENU button to exit from this sub-menu item, and you see
this:
.
exit from the given menu item, and you see this:
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in,
go on with the operation from point 2 of the Sequence of
operations.)
(3. If you don't want to exit the menu (you want to do
further settings), then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
You find a detailed training material on the limit outputs in
the Appendix, in Chapter 10.8 Limit outputs.
on the display. This is the value of
,
,
,
,
,
, etc.
(Exit) are shown on the
.
39
Advertisement
Table of Contents
