Messages of critical
errors
During code writing
During setting up
24
A/D failure (Service: AD Hardware)
EEPROM failure (Service: EEPROM Hardware)
EEPROM write error (Service: EEPROM Protected)
Calibration error (Service: Calibration)
Default factory settings (Service: Default Factory
Settings)
The last saving was not successful (Error: Last Save)
Code? (Code)
Bad Code (Bad Code)
A User login took place (User)
A Supervisor login took place (Supervisor)
The typed number is lower than allowed (Low Limit)
The typed number is higher than allowed (High Limit)
Low numeric value not possible to display
High numeric value not possible to display
Re-type it please. (Re-type)
Automatic escaping (Auto Escape) — after 1 minute
Exit from the setting (Exit)
The instrument is making calculations, please wait
(Busy)
The requested operation has been completed ( (Ready)
The saving of the settings is being done (Save)
No, I don't want this menu (No)
Yes, the menu can be started (Yes)
DT9500
20220103-V2