Table of Contents
Advertisement
DT9500
Setting the operating
mode
Sequence of operations
Low limit value
Sequence of operations
20220103-V2
6. After you have selected the desired operating mode for
the limit output, press the MENU button. This takes you out
from the given sub-menu item, and you see this:
7. If you had selected the
no need to do any further settings. For finishing the
operation, please go on from the point Exit from the menu
item.
8. Keep stepping by pressing the ▲ button as long as you
see this sub-menu item:
the low limit value. Here you can define the numerical
value by which the device will compare the measured
physical values.
9. Enter by pressing the ENTER button.
10. You see this
is blinking in the upper left corner. The arrow indicates that
the uppermost digit (the „half" digit) is being selected from
the 4 and half digits, and now it can be modified by
pressing the ▲ button.
11. Pressing the ► button you can select the next digit.
12. Pressing the ▲ button you can increase the value of
the blinking digit:
,
,
,
,
13. When the last digit (right-side) is being selected, and
you press the button ►, a blinking colon appears on the
left side:
plus/minus sign is being selected, and it can be modified by
pressing the ▲ button.
or the
. LL (Low Limit) means:
on the display and the arrow (
,
,
,
,
,
. The colon indicates that the
mode, there is
←
, etc.
.
)
35
Advertisement
Table of Contents
