Table of Contents
Advertisement
A pole clamp is fitted to the rear of the pump and will provide secure fixing to vertical I.V. poles of a diameter between 15 and 40 mm.
Recessed
area
*
Rectangular bar
Getting Started (Continued)
Pole Clamp Installation
1.
Pull the folded pole clamp towards you and unscrew the clamp to leave enough
room for the size of the pole.
2.
Place pump around pole and tighten screw until the clamp is secured to the pole.
*
A
Docking Station/Workstation* or Equipment Rail Installation
Rotating
Release lever (push
to release)
1000DF00498 Issue 3
Never mount the pump such that the infusion stand becomes top heavy or
unstable.
Ensure pole clamp is folded away and stored within recessed area at the
rear of the pump before connecting to a Docking Station/Workstation* or
when not in use.
The rotating cam can be fitted to the rectangular bar on the
Docking Station/Workstation* or equipment rails measuring 10mm
cam
by 25mm.
1.
Align the rotating cam on the rear of the pump with the
rectangular bar on the Docking Station/Workstation* or the
equipment rail.
2.
Push the pump firmly onto the rectangular bar or equipment
rail.
Ensure that the pump 'clicks' securely into position onto
the rail or bar .
3.
To release, push the release lever and pull the pump
forwards.
A
It is recommended that infusion bags be located on a
hanger directly above the pump with which they are
being used. This minimises the potential for confusion
of infusion sets when multiple volumetric pumps are
used.
*Alaris® DS Docking Station and Alaris® Gateway Workstation.
Pump can only be mounted on the horizontal section of the docking stations listed
above.
11/42
Advertisement
Table of Contents
