Scanner Problems - Epson GT-10000+ User Manual

Scanner Problems

The OPERATE light doesn't
come on or blinks slowly
Check the scanner power cord.
Make sure the power cord is
securely plugged into the scanner
and the power outlet, and that the
scanner is turned on. Also, check
that the power outlet is working and
provides sufficient power for the
scanner.
The READY light doesn't
come on or flashes
Check the scanner power cord.
Make sure the power cord is
securely plugged into the
scanner and the power outlet,
and that the scanner is turned
on.
Check that the power outlet is
working and provides sufficient
power for the scanner.
If you're using an automatic
document feeder and both the
READY and ERROR lights are
off, make sure it is closed (lying
flat against the document table).
Also, make sure the automatic
document feeder doesn't have a
paper jam and isn't out of
paper. (See Chapter 3.)
The scanner doesn't scan your
image
Make sure the scanner is ready
to scan. Wait until the READY
light stops flashing and remains
on.
Check your image source
setting. Make sure
is selected, or, if
TWAIN Pro
you are printing over a network,
make sure
EPSON TWAIN Pro
is selected.
Network
Run the scanner test to make
sure the scanner is
communicating with your
computer. (See Chapter 2 or
Chapter 6.)
Make sure you have enough
memory to scan your image. If
you're scanning a large image or
scanning at a high resolution,
try closing other programs
before you scan. If your
computer still doesn't have
enough memory to process the
image, try scanning at a lower
resolution, or select part of the
image to scan.
Make sure the SCSI terminator
is set up correctly and the
scanner's SCSI ID doesn't
conflict with another SCSI
device. (See Chapter 1.)
EPSON
Solving Problems
99