Epson GT-10000+ User Manual page 110

Check for conflicts in your
SCSI ID number setting, I/O
address, the interrupt setting for
your SCSI board, and other
settings. For information about
the SCSI ID setting, see
page 11. For information about
choosing other settings, see your
computer manual.
Check your image source setting
in the Select Source window.
Make sure you selected
. (If you also
TWAIN Pro
installed EPSON Scan Server
on your computer, make sure
it's not running.)
If you don't see
EPSON
in the Select
TWAIN Pro
Source window, uninstall your
software, then reinstall it. See
the instructions on page 107.
If you have another EPSON
scanner and have a previous
version of EPSON TWAIN
installed, uninstall the older
version. See the instructions for
uninstalling software on
page 107.
You can't start EPSON TWAIN
Pro Network from a client
computer
EPSON
Make sure the scanner, the
scanner server, and EPSON
Scan Server are turned on and
running. (See Chapter 6.)
Make sure the cables connecting
the scanner, the scanner server,
and the client computer meet
the system requirements on
page 126 and are properly
connected.
Make sure the correct IP address
for the scanner server is entered
in the EPSON TWAIN Pro
Network window for the client
computer. (See page 88.)
Make sure the network interface
card is installed correctly in
both the scanner server and the
client computer.
Make sure both the scanner
server and client computer are
running the TCP/IP protocol.
(If you need to install TCP/IP,
see Appendix A.)
If more than one scanner is
connected to the scanner server,
make sure the EPSON
GT-10000 is selected as the
default scanner.
Solving Problems
101