Epson GT-10000+ User Manual page 91

If you're installing EPSON TWAIN Pro Network in order to use a scanner
attached to another computer, you'll see a window that asks for the
Network Scanner Address (the scanner server's IP address). Enter the IP
address for the scanner server you want to connect to. See page 88 for
instructions. Then continue with step 5 below.
5. Click
Test
computer, you see
to close the window.
6. Follow the instructions on the screen to install
EPSON Scan Server. When you see the
window on the right, make sure
selected under Scanner Selection.
Select either
scanner server start up mode. (See "Changing
the Scanner Server Start Up Mode" on
page 85 for details about the start up mode.)
7. Click
Test
OK. Scanner available
if the scanner is communicating with the
scanner server. Then click
If you want to share a different network scanner with the client
computers, you can access the EPSON Scan Server window at any time
by double-clicking the EPSON Scan Server icon in the Windows Control
Panel. Then select the scanner you want in the Scanner Selection list.
8. Follow the instructions on the screen to complete installation of additional
software you selected in the software selection window.
9. If you want to install PhotoDeluxe, see page 45 for instructions. When you're
done installing software, restart your computer.
82
Network Scanning
to check scanner operation. If the scanner is communicating with your
Status: Device Reader
or
Icon Dialogbox
to test scanner operation.
appears under Status
.
OK
under Scanner Information. Click
is
GT-10000
as the
OK