Pentair SunTouch Installation And User Manual page 5

WARNINGS AND IMPORTANT SAFETY PRECAUTIONS
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION:
PUMPS REQUIRE HIGH VOLTAGE WHICH CAN SHOCK,
BURN, OR CAUSE DEATH.
BEFORE WORKING ON PUMP!
Always disconnect power to the pool pump at the
circuit breaker from the pump before servicing the
pump. Failure to do so could result in death or
serious injury to service person, pool users or
others due to electric shock.
Before attempting installation or service of the SVRS Alarm, be sure all power
to the circuit supplying AC power is disconnected/switched off at the circuit
breaker. The SVRS Alarm must be installed by a qualified professional.
Grounding (earth bonding) is required to the SVRS Alarm.
Install the pump a minimum of five (5) feet from the inside wall of the pool
and spa. Canadian installations require a minimum of three (3) meters from
pool water.
A pool or spa pump must be installed by a qualified pool and spa
service professional in accordance with the National Electrical Code and all
applicable local codes and ordinances. Improper installation may create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due to electrical shock, and
may also cause damage to property.
Pumps produces high levels of suction, which can pose extreme danger if a
person comes in close proximity to an open pool or spa drain or a loose or
broken drain cover or grate. The pump, when installed according to the manufacturer's
instructions, is designed to help prevent injuries caused by body entrapment in pools. Pumps
does not, however, protect against limb entrapments, disembowelments (when a person sits on a
broken or uncovered pool drain) or hair entanglements.
Pumps improperly sized or installed or used in applications other
than for which the pump was intended can result in serious personal injury or
death. These risks may include but not be limited to electric shock, fire, flooding, suction
entrapment or serious injury or property damage caused by a structural failure of the pump or
other system component.
The IntelliFlo® VS+ SVRS and IntelliPro® VS+ SVRS pump is capable of
generating systems pressures up to 50 psi. Installers must ensure that all
system components are rated to withstand at least 50 psi. Over pressurizing
the system can result in catastrophic component failure or property damage.
SVRS Audible Alarm Installation and User's Guide
iii