Troubleshooting (Status And System Alert Messages) - Pentair SunTouch Installation And User Manual

6

Troubleshooting (Status and System Alert Messages)

The following alert messages may be displayed if a system error is detected.
Pump is Not
Running
System Normal
1520 rpm 340 Watt
SVRS Alarm !!!
Blockage Alarm
Check for Drain
!!! Blockage !!!
Communication
With Pump Alarm
Soft Restart in
xxx Seconds
Full/Hard Prime
in xxx Seconds
Soft Restart in
5 Seconds
Full/Hard Prime
in 5 Seconds
SVRS Audible Alarm Installation and User's Guide
The pump is not running. Either the pump is in
'manual" mode or is not scheduled to run at this time.
To start the pump; press the SVRS alarm control
panel Menu button, press the Right arrow button
(disable alarm) on the SVRS alarm (this enables
"Service" mode). Press the pump's Start/Stop button
two times (be sure the LED above the Start/Stop
button is on). To reactivate the SVRS alarm, press
the Menu button. For information about "schedule"
mode, see page 1.
The pump is on and running normally and the alarm is
enabled. The current RPM and Wattage is displayed.
An SVRS event has occurred. The pump has
stopped and the alarm is activated. If the optional
ESO3 emergency switch option is installed; pressing
the switch will switch OFF AC power to the pump.
A communication failure has occurred between the
system and pump. Check the RS485 communication
cable between the pump and the SVRS Alarm power
center.
Before a pump "Soft Prime" or Full/Hard Prime"
restart mode is initiated, the countdown seconds are
displayed as defined in the pump's "SVRS Auto
Restart" setting (default 120 seconds, "Auto Restart"
disabled/Enabled). For more information, see page 7.
If the pump's "SVRS Auto Restart" feature is
disabled, the pump restarts (in "Soft Prime" or "Full/
Hard Prime" mode) after a five second countdown.
For more information, see page 7 -8.