Main Menus; Access The Menu - Pentair SunTouch Installation And User Manual

➂
MENU button: Use the Menu button to access the main menu items. There
are five (5) menu items to select from. Press the MENU button to scroll
though each of the five menu items. The main menu items are displayed
MENU
along with the menu number (1/5). To exit the main menu item, press the
Menu button until the main status screen displays. If no menu activity is
detected after five minutes, the main status screen is displayed. All menu
settings are permanently saved and retained in the SVRS Alarm control
panel even after power is removed from the control panel.
➃
Right button: While in the main menu, use the Right arrow button to select
a menu setting or to return to the main menu items. After changing a menu
item setting or value, it is automatically saved.
SELECT
➄
Up and Down arrow button: After an SVRS blockage has occurred, press the
Reset/Restart button to silence the audible alarm then press both buttons
simultaneously two times to initiate a pump "hard" prime restart. Pressing
these buttons the second time will also disable the "SVRS Auto restart"
protection feature during the priming mode. If the Reset/Restart button is
pressed to silence the audible alarm allowing the pump to start in "soft prime"
mode, this may turn off "priming' on the pump. Pressing the Up/Down arrow to
start the pump in "hard prime" mode may enable "priming." Before doing so, be
sure to clear the suction outlet of the blockage. If the buttons are pressed
simultaneously only one time, a pump "soft" prime restart is initiated. This
condition occurs after the Reset/Restart button is pressed to initiate a soft
prime restart. These buttons are also used to toggle "Clear Errors Counters"
No/Yes setting. See Menus, page 5.

Main Menus

Main Menu [1 / 5] *Alarm Disabled*
Service / Alarm Service Mode
MENU
Main Menu [2 / 5] Alarm Activating
For 4 seconds
Tst Alarm Output
MENU
Main Menu [3 / 5]
Total SVRS Event
Alarm Count
Count
MENU
Main Menu [4 / 5] Firmware
Firmware Version Version x.xxx
MENU
Main Menu [5 / 5]
Version x.xxx
Run Factory Test
Press Any Button
System Normal
1520 rpm 340 Watt
MENU
Access the Main Menu
To access the menu items, Press the Menu button. Press the Right arrow
button to access the menu item. Use this button to view a menu setting and
to exit a setting and return to the main menu (1-5). Note: Use the Up/Down
arrow button to select "Clear Errors Counters" No/Yes setting.
Press any button
Re-Enabled Alarm
to enable alarm
System Active
SVRS Error Since
0 Last View 0
Follow screen prompts
Status: Passed
to run test
Code: None
Main Menu [1/5]
Service / Alarm
SELECT
SVRS Audible Alarm Installation and User's Guide
Com Errors Since
Total Com Error
Last View
Count 0
Clear Errors
Counters No/Yes
3
0