Manual Mode; Svrs Power Center Control Panel; Control Buttons - Pentair SunTouch Installation And User Manual

2
•
Manual mode (see page 9):
are setup manually from the pump's control panel. If an SVRS
blockage event occurs in manual mode, check the suction outlets
for a blockage then press the RESET/RESTART button to
deactivate the alarm.
automatically in "Soft Prime" mode.
must first place the SVRS alarm system in "SERVICE MODE,"
press one of the pump SPEED buttons, press the START/STOP
button then press the MENU button to re-enable the alarm system.
Press the MENU button until the main screen is displayed.
Note: For IntelliFlo pump operating information, see the IntelliFlo
VS+ SVRS and IntelliPro VS+ SVRS pump Installation and User's
Guide (P/N 353850).
SVRS Alarm Power Center Control Panel
Use the SVRS Alarm control panel buttons to access the menu items and setup
system settings.
➀

Control Buttons

➀
Liquid Crystal Display (LCD): The main system display consists of a 16 x 2
alphanumeric character LCD with backlighting for easy viewing.
➁
Reset/Restart button: After a SVRS blockage event occurs, check the suction
outlets for a blockage then press this button to turn off the audible alarm.
Further action maybe necessary to restart the pump. For more information, see
RESET/
RESTART
page 7.
SVRS Audible Alarm Installation and User's Guide
Each of the four pump speed buttons
Note: The pump will not restart
SVRS ALARM
TM
System Normal
1520 rpm 340 watt
RESET/
MENU
RESTART
➁ ➂
SVRS Alarm Control Panel
To restart the pump, you
SELECT
➃
➄