Connecting Intelliflo Pump To Svrs Power Center - Pentair SunTouch Installation And User Manual
Safety vacuum release system (svrs) audible alarm for use with intelliflo vs+ svrs and intellipro vs+ svrs pumps
Hide thumbs
Also See for SunTouch:
- Installation and user manual (88 pages) ,
- Quick reference manual (2 pages) ,
- Installation and user manual (92 pages)
Table of Contents
Advertisement
20
Connecting IntelliFlo VS+ SVRS pump to the
SVRS Alarm Power Center
The IntelliFlo VS+ SVRS pump is connected to the SVRS Alarm circuit board
center using the 50 ft. two-conductor communication cable (provided with pump).
To connect the IntelliFlo pump communication cable (See Figure 2)
1. Route the two conductor cable from the pump up through the
Power Center grommet opening located on the left side, and up
through the low voltage raceway to the circuit board.
2. Strip back the cable conductors ¼ in. Insert the wires into the
screw terminals (provided in the kit). Secure the wires with the
screws. Make sure to match the color coding of the wires (see
Figure 2 below).
3. Insert the terminal connector on the COM PORT (J11) screw
terminal on the circuit board.
GAS
HEATER
RESET
CR2032
+3V
COM PORT
J11
Figure 2
SVRS Audible Alarm Installation and User's Guide
SVRS Alarm
circuit board
CLNR
SVRS Audible
Alarm
5
COM PORT (J11)
screw terminal
S
u
n
T
o
u
c
h
n I
e t
l l
F i
o l
s
c
e r
w
t
r e
m
n i
l a
(
- 2
w
i
e r
c
a
l b
) e
c
o
n
n
e
t c
r o
2
(
G
R
N
)
G
R
E
E
N
P (
n i
) 6
3
Y (
E
) L
Y
E
L
L
O
W
P (
n i
) 7
Pin configuration
- Quick Links:
- Manual Mode
Hide quick links:
Advertisement
Table of Contents
