Table of Contents
Advertisement
CMOS Setup Utility – Copyright © 1984 – 2000 Award Software
IDE HDD Auto-Detection
IDE Primary Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
← : MoveEnter : Select
↑ ↑ ↓ ↓ →
→ ←
Help
F5:Previous Values
IDD HDD Auto-Detection: Press <Enter> while this item is high-
lighted if you want the Setup Utility to automatically detect and
configure a hard disk drive on the IDE channel.
If your system has an IDE hard drive, you can use this utility to de-
tect its parameters and enter them into the Standard CMOS Setup
automatically.
If the auto-detected parameters displayed do not match the ones that
should be used for your hard drive, do not accept them. Press the
<N> key to reject the values and enter the correct ones manually in
the Standard CMOS Setup screen.
Note: If you are setting up a new hard disk drive that supports
LBA mode, more than one line will appear in the parameter
box. Choose the line that lists LBA for an LBA drive.
Do not choose Large or Normal if the hard disk drive is already fully
formatted when you installed it. Select the mode that was used to
format it.
Standard CMOS Features
IDE Primary Master
Press Enter
[Auto]
[Auto]
0 MB
0
0
0
0
0
+/-/PU/PD:Value: F10: Save ESC: Exit F1:General
F6:Fail-Safe Defaults
KT Mainboard BIOS
Item Help
Menu Level
To auto-detect the
HDD's size, head . . . on
this channel
F7:Optimized Defaults
37
Advertisement
Table of Contents
