Seat toledo Owner's Manual page 46

HANDLING INSTRUCTIONS
2 – – C C oolant t t emperature
The gauge starts to work when the igni-
tion is switched on.
When the ignition is switched on the
warning lamp (c) flashes for a few sec-
onds as a functional check.
a – – C C old
Avoid high engine speeds and do not
work engine too hard yet.
b – – N N ormal
When the vehicle is driven normally the
needle should settle down in the central
zone.
When engine is working hard and the
ambient temperature is high, the needle
may move a long way up.
This i i s n n ot s s erious a a s l l ong a a s t t he
warning l l amp ( ( c) d d oes n n ot f f lash.
c – – W W arning l l amp
If the lamp flashes and a tone is heard at
the same time when driving, first check
the coolant temperature being displayed.
If the needle is in the normal zone,
coolant should be added as soon as pos-
sible. See the chapter on "Cooling sys-
tem".
2.6 ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
All manuals and user guides at all-guides.com
If the needle is in the right half of the indi-
cator, the coolant temperature is too high.
In t t his c c ase, p p ull o o ver, s s witch t t he
engine o o ff, w w ait u u ntil i i t c c ools and then
look for the cause of the problem. See the
chapter on "Cooling system".
Additional l l ights i i n f f ront o o f t t he c c ool-
ing a a ir i i ntake i i nterfere w w ith t t he f f low
of c c ooling a a ir. A A t h h igh a a mbient t t em-
peratures a a nd f f ull t t hrottle t t here i i s a a
danger t t hat t t he e e ngine w w ill t t hen o o ver-
heat.
Warning
Note w w arnings i i n " " Cooling s s ystem"
chapter.
IB9-035
INSTRUMENT PANEL