Seat toledo Owner's Manual page 210

TIPS AND MAINTENANCE
– Wind jack arm up by turning the crank in
the spindle until the jack just goes
under the vehicle.
– The claw of the jack must fit round the
vertical rib on the side member so that
the jack cannot slip when vehicle is
lifted – see illustration on the page
3.67.
– Align jack and at same time wind claw
up further until it contacts the vertical
rib on side member.
•
Lift vehicle until the wheel is just clear
of the ground.
3.68 –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
All manuals and user guides at all-guides.com
•
using box spanner in screwdriver handle
(see illustration), place them on a clean
surface (hub cap, cloth, paper) next to the
jack and remove wheel.
•
bolts using the box spanner in the screw-
driver handle.
The w w heel b b olts must b b e c c lean a a nd
easy t t o t t urn – – d d o n n ot g g rease o o r o o il
under a a ny c c ircumstances!
•
diagonal sequence using wheel spanner.
•
When fitting the wheel trim, you must first
press on the trim at the valve cut-out and
then press on around the full circumfer-
ence.
•
bracket and secure using handwheel.
•
holes and use it to secure the polystyrene
retainer for the vehicle tools.
Remove wheel bolts (after l l oosening),
Fit spare wheel, and slightly tighten all
Lower vehicle and fully tighten bolts in
Fit the wheel trim again.
Place defective wheel in spare wheel
Feed the securing strap through the
B45-085C
IF AND WHEN