Table of Contents
Advertisement
2. Enter the admin password. The default is admin. To switch between entering upper or
lower-case letters, press the * key.
3. On the Admin settings menu, select Firmware update.
The handset/deskset checks for new firmware. If new firmware is found, the
handset/deskset screen asks you to proceed with the update.
Only one handset/deskset at a time can perform a firmware update. The base
LEDs flash to indicate the base is busy and all incoming calls are rejected while
the update is in progress.
Using the WebUI
VDP650 Administrator and Provisioning Manual
90
Back to Contents
Advertisement
Table of Contents
