Table of Contents
Advertisement
Setting
Authentication name
Authentication password
Dial Plan
Inter Digit Timeout (secs)
Maximum Number of
Calls
Feature Synchronization
DTMF method
Unregister after reboot
Call Rejection Response
Code
Using the WebUI
VDP650 Administrator and Provisioning Manual
Description
If authentication is enabled on the server, enter the
authentication name (or authentication ID) for
authentication with the server.
If authentication is enabled on the server, enter the
authentication password for authentication with the server.
Enter the dial plan, with dialing strings separated by a |
symbol. See
"Dial Plan" on page
Sets how long the VDP651 waits after any "P" (pause) in
the dial string or in the dial plan.
Select the maximum number of concurrent active calls
allowed for that account.
Enables the VDP650 to synchronize with BroadWorks
Application Server. Changes to features such as DND, Call
Forward All, Call Forward No Answer, and Call Forward
Busy on the server side will also update the settings on the
VDP651 menu and WebUI. Similarly, changes made using
the VDP651 or WebUI will update the settings on the
server.
Select the default DTMF transmission method. You may
need to adjust this if call quality problems are triggering
unwanted DTMF tones or you have problems sending
DTMF tones in general.
Enables the phone to unregister the account(s) after
rebooting-before the account(s) register again as the
phone starts up. If other phones that share the same
account(s) unregister unexpectedly in tandem with the
rebooting VDP650, disable this setting.
Select the response code for call rejection. This code
applies to the following call rejection cases:
User presses
Reject
when Call Forward Busy is enabled)
DND is enabled
Phone rejects a second incoming call with Call
Waiting disabled
Phone rejects an anonymous call with Anonymous
Call Rejection enabled
Phone rejects call when the maximum number of
calls is reached
40
41.
for an incoming call (except
Back to Contents
Advertisement
Table of Contents
