Table of Contents
Advertisement
To access the WebUI:
1. Ensure that your computer is connected to the same network as the VDP650.
2. Find the IP address of the VDP650:
a. On a handset, press MENU/SELECT.
b. Press to highlight Status, and then press MENU/SELECT.
c. With Network highlighted, press MENU/SELECT.
The Network status screen appears.
d. On the Network status screen, note the IP Address.
3. On your computer, open an Internet browser. (Depending on your browser, some of the
pages presented here may look different and have different controls. Ensure that you
are running the latest update of your preferred browser.)
4. Type the VDP650 IP address in the browser address bar and press ENTER on your
computer keyboard.
The browser displays a window asking for your user name and password.
5. For the user name, enter admin. For the password, enter the default password,
admin. You can change the password later on the WebUI Security page, available
under Servicing.
6. Click OK.
The WebUI appears.
Click topics from the navigation bar along the top of the WebUI, and then click the links
along the left to view individual pages. For your security, the WebUI times out after 10
minutes, so if it is idle for that time, you must log in again.
Most WebUI configuration pages have a
you have made on the page. During a configuration session, click
move on to the next WebUI page.
The remaining procedures in this section assume that you are already logged into the WebUI.
Using the WebUI
Network
IP Address:
10.88.51.133
DHCP:
Enabled
BACK
OK
VDP650 Administrator and Provisioning Manual
button. Click
35
to save changes
before you
Back to Contents
Advertisement
Table of Contents
