Peripherals - Barco CX-20 Installation Manual

CX-20 Configurator
To enable CEC, check the check box before Enable CEC.
Audio
Enable or disable audio output.
Check the check box in front of Enable audio to enable audio output.
Screen saver setup
1. Log in to the Configurator.
Image 6–13
2. Click Display & Audio → Display & Audio.
3. To activate the screen saver, drag the slider bar to the left or to the right until the desired delay time is
reached.
When the slider is set completely to the left, the screen saver will never be activated.
4. Click Save changes.

6.8 Peripherals

Overview
ClickShare Conference allows you to connect the room speakerphone, microphone and camera wireless to
your laptop and use the better equipment of the room in your video conferencing call.
The Peripheral page gives an overview of the connected devices and their status.
Firmware update peripherals
Update of firmware of the peripheral devices via the configurator is supported for Logitech Meetup and Rally
and only when the camera is not in use.
When the installed firmware version is lower than the Barco certified peripheral firmware version, then the
install button becomes active. Click on Install the install the latest version.
How to get an overview
1. Log in to the Configurator.
2. Click Display & Audio → Peripherals.
70 R5900102 /04 CX-20