Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
few minutes, go back to the Connection 1 Setup menu, check
the settings and make sure they are correct.
3.6 Create a New Connection
An alternative method of changing the connection type used by
the WA1003A-RU is to create a new connection. Creating a new
connection will not change the Connection 1 settings, it will make a
new set of coneciton configuration settings. The new set created will
be labeled Connection 2, additional connections created will be
likewise labeled Connection 3, Connection 4 and so on. Use the
method described here to create up to 8 different connection
configuration sets. At any time you may reconfigure the settings for
any previously created connection by clicking on the menu button for
the connection displayed under the WAN Setup heading.
I. New Connection Example 1 - Create a New PPPoE
Connection
The example below describes how to set up a new connection
that uses a PPPoE type WAN conneciton. To create a new
connection:
1. Click on the New Connection button.
2. Configure the WA1003A-RU for the Type: of conneciton used
and all the remaining settings as discussed in the preceding
section. In this example, the type of connection used for
Connection 2 is PPPoE. Notice also that the VPI and VCI
values have been changed.
3. Click the Apply button to cerate the new connection. Notice
that a new menu button is created (Connection 2), this links to
Chapter 3 Configuring
3-37
Advertisement
Table of Contents
