Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
connections (except Bridge connections) when they are first set up.
Firewall protection includes the previously discussed Port Forwarding
and Access Control. Therefore, this must be enabled to use these
features.
To enable NAT and Firewall protection for any WAN connection
including Bridge type connections, check the Enable NAT and
Firewall Services selection box and click the Apply button. Be sure
to save the changes in the System Commands menu or the settings
will be lost.
To disable NAT and Firewall Services, deselect it and click the
Apply button. Be aware that this remove basic security and expose
your LAN to potentially malicious agents form the WAN.
Remember to save the configuration changes.
DMZ IP Address
A DMZ address is used for a device that is not given basic
protection of NAT and Firewall services. You may select an IP address
from the pull-down menu or create a New IP by pressing the button.
This brings up the LAN Clients menu in which you may create a static
client IP or reserve a dynamically assigned IP address for DMZ
designation.
Setup Remote Management
Telnet and web management through the WAN port can be
enabled for specified IP addresses. To enable remote management,
click to check the selection box for Remote Telnet or Remote Web
and type in an IP address and net mask of a trusted host.
Chapter 3 Configuring
3-58
Advertisement
Table of Contents
