Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
5. Based upon the information your ISP provided, enter the IP
Address (e.g. 168.128.1.1), the Subnet Mask (e.g.
255.255.255.0), ARP Server (e.g. 168.128.1.2) and the
Default Gateway (e.g. 168.128.1.1).
6. If you are told to change the VPI or VCI values, type in the
values given to you by your service provider. Many users will
be able to use the default settings.
7. Leave the default QoS values if you are unsure or the ISP did
not provide this information.
8. Do not change the PCR or SCR values unless you are
required to do so. If you are told to change these, type in the
values given to you by your service provider.
9. Click the Apply button when you have entered all the
information. The web browser will briefly go blank. You are
now finished changing setting for the primary WAN
connection known as Connection 1. It is now necessary to
save the changes you just made and restart the
WA1003A-RU.
10. To save the changes made to Connection 1, click the Tools
tab and then click on the System Commands button. Click on
the Save All button to store the configuration settings. Click
on Back button to return to the System Commands menu.
11. Check the WAN connection status. Click the Status tab and
then the Connection Status button. Look under WAN to view
the State of Connection 1, it should read Connected. If the
WAN connection state does not appear to Connected after a
Chapter 3 Configuring
3-36
Advertisement
Table of Contents
