Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
To configure the WAN connection for DHCP, perform the steps
listed below. Some of the settings do not need to be changed the first
time the device is set up, but can be changed later if you choose.
1. Click the Connection 1 button under WAN Setup to view the
default PPPoA Connection Setup configuration menu.
2. Select DHCP from the Type: pull-down menu. This action will
change the menu so it offers different settings for
configuration.
3. Type in a Name: in the space provided (WAN_PPPoA is used
in the above example).
4. If you are told to change the VPI or VCI values, type in the
values given to you by your service provider. Many users will
be able to use the default settings.
5. Leave the default QoS values if you are unsure or the ISP did
not provide this information.
6. Do not change the PCR or SCR values unless you are
required to do so. If you are told to change these, type in the
values given to you by your service provider.
7. The Encapsulation values LLC (SNAP) and VC (MUX) are
two different methods of encapsulating the PPP packet.
Contact your ISP to make sure which encapsulation is being
supported.
8. Click the Apply button when you have entered all the
information. The web browser will briefly go blank. You are
now finished changing setting for the primary WAN
connection known as Connection 1. It is now necessary to
Chapter 3 Configuring
3-33
Advertisement
Table of Contents
