Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
4. Click on the Add> button to place the rule in the Applied
Rules list of port forwarding that are actively applied to the
client
The Available Rules can be applied to a single client IP address.
That is, it is not possible to use an applied rule for multiple IP
addresses on the LAN.
To set up custom TCP or UDP access control rules, follow these
steps:
1. Select the User category and click the Add button located
below the Available Rules list.
2. In the new menu that appears, type a Rule Name in the space
provided.
3. Select the port Protocol from the pull-down menu - you may
select TCP, UDP or both (TCP/UDP).
4. Configure a range of ports for forwarding. Type the lowest
numbered port in the range in the Port Start space. Type the
highest numbered port in the Port End space. For a single port,
just enter the same number in both spaces.
5. Type a number for the Port Map in the space provided.
6. Click the Apply button to create the new rule. The new rule
will appear listed in the table of custom port control rules.
3.10.6 Advanced Security
Use the Advanced Security features of the WA1003A-RU to
globally enable or disable NAT and Firewall protection for any WAN
connection, enable or disable DMZ IP addresses, enable or disable
Chapter 3 Configuring
3-56
Advertisement
Table of Contents
