Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
4. If you are told to change the VPI or VCI values, type in the
values given to you by your service provider. Many users will
be able to use the default settings.
5. Leave the default QoS values if you are unsure or the ISP did
not provide this information.
6. Do not change the PCR or SCR values unless you are
required to do so. If you are told to change these, type in the
values given to you by your service provider.
7. The Encapsulation values LLC (SNAP) and VC (MUX) are
two different methods of encapsulating the PPP packet.
Contact your ISP to make sure which encapsulation is being
supported.
8. Based on the information provided by your ISP, enter the IP
Address, Subnet Mask, Default Gateway (if provided), and
Domain Name Services (DNS) values (if provided).
9. Select the desired Mode, Bridged or Routed.
10. Click the Apply button when you have entered all the
information. The web browser will briefly go blank. You are
now finished changing setting for the primary WAN
connection known as Connection 1. It is now necessary to
save the changes you just made and restart the
WA1003A-RU.
11. To save the changes made to Connection 1, click the Tools
tab and then click on the System Commands button. Click on
the Save All button to store the configuration settings. Click
on Back button to return to the System Commands menu.
Chapter 3 Configuring
3-31
Advertisement
Table of Contents
