Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
Table 2-1 Information you will need from your ADSL service provider
This is the Username used to log on to your ADSL service
provider's network. It is commonly in the form −
Username
user@isp.com. Your ADSL service provider uses this to
identify your account.
This is the Password used, in conjunction with the Username
Password
above, to log on to your ADSL service provider's network.
This is used to verify the identity of your account.
This is the method your ADSL service provider uses to send
and receive data between the Internet and your computer.
Connection
Your Modem supports the following connection protocols:
Protocol
PPPoE, PPPoA, PPPoA with DHCP, Bridge, and CLIP
(IPoA).
ADSL uses various standardized modulation techniques to
transmit data over the allotted signal frequencies. Some
users may need to change the type of modulation used for
Modulation
their service. The default DSL modulation (MMODE) used for
Type
the WA1003A-RU automatically detects all types of ADSL
modulation. However, if you are instructed to specify the
modulation type used for the WA1003A-RU, you have three
alternatives: G.LITE, G.DMT and T1.413
This is the method your ADSL service provider will use to
Security
verify your Username and Password when you log on to their
Protocol
network. Your Modem supports the PAP and CHAP
protocols.
This is the Virtual Path Identifier (VPI). It is used in
conjunction with the Virtual Channel Identifier (VCI) below, to
VPI
identify the data path between your ADSL service provider's
network and your computer.
This is the Virtual Channel Identifier (VCI). It is used in
conjunction with the VPI above to identify the data path
VCI
between your ADSL service provider's network and your
computer.
Chapter 2 Installation
2-6
Advertisement
Table of Contents
