During Systems Operation; Emc Guidance And Declaration - Vatech EzScan-i User Manual

10.8 During Systems Operation

WARNING
mechanical elements and therefore should be handled
carefully. Do not drop, bump, or shake the handpiece or the
tip. Always place the handpiece on the Base when not in use.
Do not put stress on the cable connecting the handpiece to
the Base. Do not submerge the handpiece or the Base in any
liquid. Do not place the handpiece or the Base on wet or
heated surfaces. Hold the handpiece with a firm grip when
handling it.
WARNING
ventilation opening at the bottom of the handpiece should
never be obstructed.
NOTE: During operation of the system, the handpiece and the tip
may get slightly warm; this is normal.

10.9 EMC Guidance and Declaration

WARNING: Portable RF communication equipment (including peripherals such as
antenna cables and external antennas) should not be used within 30 cm of any part
of the EzScan, including cables specified by the MANUFACTURER. Otherwise,
performance degradation of this equipment may occur.
WARNING: Use of this equipment adjacent to or on other equipment must be
avoided as it may result in improper operation. If this use is necessary, it is
advisable that this and the other equipment be observed to verify that they are
operating normally.
EzScan Performance: Under normal use, the EzScan should be transmit images to
Page 60
: The EzScan system contains delicate optical and
: In order to prevent over-heating of the system, the
User Manual