Scanner Docking Base And Handpiece; Calibration; Wall Mount Installation Instructions (Optional) - Vatech EzScan-i User Manual

3.6 Scanner Docking Base and Handpiece

The scanner body consists of the Docking Base and Handpiece, which are
connected by a flexible, non-detachable cable.

3.7 Calibration

The EzScan™ intraoral scanner is factory calibrated. In the case of calibration issues
due to transport, please contact your reseller or Vatech support technician.

3.8 Wall Mount Installation Instructions (Optional)

When wall mounting the scanner's base, be careful to respect measurements
indicated to drill holes for the wall mount.
•
It is recommended to use wall anchors and threaded screws with an 8mm
(5/16th inch) head diameter.
•
A 4-5mm (3/16th in) distance between wall and bottom screw head is
recommended.
Caution
possibility of the base falling and damaging the scanner.
IMPORTANT: Vatech is not responsible for accidents or damage
caused in the event the scanner falls.
:
If the docking base is not properly installed there is a
Page 11