Replacing The Hard Disk Drive; Power Supply Mounting Screws - Cabletron Systems FRX6000 Maintenance Manual

4. Remove the four power supply mounting screws from the back
of the node.
Power Supply Screws
Figure 3-7 Power Supply Mounting Screws
5. Lift out the power supply.
6. Install the replacement power supply by reversing the removal
procedure.

Replacing the Hard Disk Drive

Location – see Figure 3-3
Cabletron part number = 85202001.
1. If you want to back up the database from the existing hard disk,
insert a DOS-formatted (5.0) diskette into drive A and type (at
the DOS prompt):
2. If necessary, remove the cover. (See
3. Remove the three screws shown in the following figure, then
grasp the faceplate along the top edge and pull it forward and
down to pop it out.
Testing & Replacing Components
(on page 3-3).
copy c:\omni4000\*.dat a: [Enter]
page
.
3-4.)
3-7