Main Menu - Cabletron Systems FRX6000 Maintenance Manual

Software V ersion 4.0
M A I N M E N U
A Con figu ration
B Operation
C Statu s Displays
D Events
E Statistics
F Reports
Sekect:
Figure 2-2 Main Menu
It can probably be asssumed that if you are reading this chapter, the
node did not boot correctly as described. The remainder of this
chapter describes steps for identifying and fixing some problems.
Certain problems may be easy to track down; for example:
If there seems to be no power at all, check to make sure the
power cord is securely connected at both ends and that there is
power (of the appropriate voltage) at the receptacle.
If there is power but the hardware does not seem to be func-
tioning properly, verify the correct setting of the AC voltage
selector switch. (See
If there is an obvious problem with one or more hardware
components, go to
If the node appears to boot correctly but there is a communi-
cation problem with an async terminal, go to
Interface Controls" on
Diagnostic Procedures
Node Name = nod e 10
Chapter 3.)
Chapter 3.
page 2-20.
" COM Port
2-3