Removing The Chassis Cover; Testing Component Voltages - Cabletron Systems FRX6000 Maintenance Manual

Removing the Chassis Cover

1. Make sure the power cable is disconnected from the rear of the
device.
2. Remove the two screws shown in the following figure, then lift
the cover off.
Figure 3-4 Removing the Chassis Cover

Testing Component Voltages

Be careful! These procedures are performed with
exposed live AC and DC power.
To make sure certain components are transmitting/receiving the
proper voltages, follow this procedure:
1. Make sure the power switch is off, then disconnect the power
cable from the rear of the unit.
2. Remove the unit's cover.
3. Being careful to avoid contact with live components, reconnect
the power cable and switch the unit on.
3-4
Cover Screws
FRX6000 Maintenance Guide, Rev 03