Adding Or Replacing Cards; Installing A Card - Cabletron Systems FRX6000 Maintenance Manual

Adding or Replacing Cards

When a new or replacement RLP or Line Interface Card is shipped
from Cabletron, it should include installation instructions. The infor-
mation in this section is for reference.
1. Make certain the device is powered off, then remove the cover.
(See page 3-4.)
2. Disconnect any cables from the rear of the card.
3. Remove the retaining screw that secures the card's mounting
bracket.
Card Guides
Figure 3-18 Installing a Card
3-16
Retaining Screw
Gold-plated
Edge Connectors
FRX6000 Maintenance Guide, Rev 03
Slot Cover