Selecting A Port For Configuration; Entering The Ip Address And Subnet Mask - Cabletron Systems MicroMMAC 22ES Reference Manual

IP Routing
Use this field to enable IP Routing Services.
IP Forwarding
Use this field to enable IP Forwarding.
Proxy ARP
Use this field to enable Proxy Address Resolution Protocol (ARP).
3.4.3 Selecting a Port for Configuration
Routing Services enables you to choose the ports that you want to
configure for IP routing. To select a router port to configure for IP routing,
complete the following steps:
1. Use the arrow keys to highlight the PORT field.
2. Enter the number of the port that you want to configure for IP routing
and press ENTER.
You can enter the port number, or you can use the +PORT-
NOTE
option at the bottom of the screen to scroll through the list of
the ports on your device. To use the +PORT- option, use the
arrow keys to highlight the + (to go forward), or the - (to go
backward), and then press ENTER to scroll through the
available ports in the direction you select. You can also use the
+ and - keys to scroll through the available ports.
If you enter an invalid port number, the error message "PORT NUMBER
IS OUT OF RANGE" displays. Repeat steps 1 and 2.
3.4.4

Entering the IP Address and Subnet Mask

All IP hosts must have an IP address for each network interface. These
addresses identify each network connection.
To enter the IP address for a router port, complete the following steps:
1. Use the arrow keys to highlight the ADDRESS field.
2. Enter the IP address (using DDN format) and press ENTER.
MicroMMAC Local Management Routing Addendum
The IP General Config Screen
13