Cabletron Systems MicroMMAC 22ES Reference Manual page 35

To enable RIP Routing, complete the following steps:
1. From the IPX Router Setup screen, highlight IPX RIP and press
ENTER.
The IPX RIP Configuration screen, shown in Figure 3-9, displays.
2. Use the arrow keys to highlight the Port field.
3. Type in the number of the port on which you wish to enable RIP
routing and press ENTER.
4. Use the arrow keys to highlight the Port Level RIP field.
5. Use the ENTER key to toggle the entry to ENABLED.
6. Use the arrow keys to highlight the SAVE command field at the
bottom of the screen and press ENTER. The message "SAVED OK"
displays.
IPX Address: xxx.xxx.xxx.xxx
P o r t : 1
+PORT-
MicroMMAC Local Management Routing Addendum
MicroMMAC Local Management
System Level RIP:
Port Level RIP:
SAVE
Figure 3-9 IPX RIP Setup Screen
The IPX General Configuration Screen
DISABLED
DISABLED
RETURN
2262_09
29