Connecting Rps Power - Enterasys SecureStack C3K122-24 Hardware Installation Manual

Connect AC and RPS Power
Figure 2-9
1 AC power cord
3. Observe the power CPU LED (not shown) located on the front panel. During the initialization,
the CPU LED will start by illuminating solid amber, then start blinking green, then blinking
amber, then blinking green again until the end of the initialization, and then turns solid green.
If the switch is a standalone switch, it will take approximately 30 seconds for the switch to
start up. If the switch is a stack Manager, it can take up to 3 minutes or more to start up,
depending on the number of Member switches in the stack.

Connecting RPS Power

If you are installing an optional redundant power system (C2RPS‐SYS or C2RPS‐POE), refer to the
installation instructions supplied with the RPS.
If you are installing the switch as a standalone device, proceed to "Connecting to Console Port for
Local Management" on page 2‐19. If you are installing the switch in a stack configuration, apply
power to each switch in order, according to the procedure you use in "Configuring Switches in a
Stack" on page 2‐15.
2-18 Hardware Installation
Switch Rear View
2 AC power connector
Note: If the CPU LED illuminates solid red, there was a critical failure. For more
information about the LED indications and troubleshooting, refer to "Troubleshooting" on
page 3-1. If you need additional help, contact Enterasys Networks. Refer to
on page xvii for details
.
Caution: The C3K122-24 and C3K172-24 are not a PoE-compliant device. Do not
connect a SecureStack C2 PoE Redundant Power Supply (C2RPS-POE) to the DC power
connector. Otherwise damage to the device may result.
Precaución: El dispositivo C3K122-24 y C3K172-24 no cumple con el estándar PoE. No
conecte una fuente de poder redundante (RPS) SecureStack C2 PoE (C2RPS-POE) al
cable de corriente directa. De lo contrario, el dispositivo puede dañarse.
3 Connector for external redundant power supply
"Getting Help"