Removing An Xfp; Installing The C3K Switch; Installing C3K Switch On A Flat Surface - Enterasys SecureStack C3K122-24 Hardware Installation Manual

Removing an XFP

To remove an XFP from a
1. Attach your antistatic wrist strap (refer to the instructions in your antistatic wrist strap
package) before removing the XFP.
2. Remove the cable connected to the XFP.
3. Locate the XFP wire handle and pull down on it to release the XFP.
4. Grasp the sides of the XFP and pull it straight out of the port slot.
If storing or shipping an XFP, which has a fiber‐optic connector, insert its protective dust cover to
protect the ends of the fiber‐optic fibers from dust or contamination.
Installing the C3K
The following topics are discussed in this section:
• "Installing C3K Switch on a Flat Surface" on page 2‐9
• "Mounting a C3K Switch in a 19‐Inch Rack" on page 2‐11

Installing C3K Switch on a Flat Surface

When installing the switch on a flat surface, the installation of the rubber feet is recommended to
prevent the switch from sliding on a flat surface. Installing the rubber feet is optional if you are
installing the switch in a rack. To install the rubber feet, proceed to "Installing the Rubber Feet"
instructions below. For instructions to rack mount the switch, proceed to "Mounting a C3K Switch
in a 19‐Inch Rack" on page 2‐11.
Caution: Do NOT remove the XFP from the port slot without releasing it. The XFP is
released by pulling down on its wire handle. Attempting to remove the XFP without
releasing it can damage the XFP.
The XFP and its host switch are sensitive to static discharges. Use an antistatic wrist strap
and observe all static precautions during this procedure. Failure to do so could result in
damaging the XFP or host switch. Always leave the XFP in the antistatic bag or an
equivalent antistatic container when not installed.
Precaución: NO quite el XFP de la ranura sin antes abrir la traba ubicada en la parte
frontal del XFP. Si lo hace, puede dañar el XFP, puesto que es muy sensible a las
descargas de electricidad estática, al igual que el dispositivo host. Utilice la pulsera
antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no
lo hace, pude dañar el XFP o el dispositivo host. Mientras no esté instalado, mantenga el
XFP en su bolsa antiestática o en cualquier otro recipiente antiestático.
port slot, refer back to Figure
Switch

Installing the C3K Switch

2‐4 on page 2‐8, and proceed as follows:
SecureStack C3K Hardware Installation Guide 2-9