Removing The C3K-2Xfp From The C3K Switch - Enterasys SecureStack C3K122-24 Hardware Installation Manual

Installing the C3K-2XFP Input/Output Module
Figure 2-1
1 Guide rails

Removing the C3K-2XFP from the C3K Switch

This section describes how to remove your C3K‐2XFP from your C3K switch. Your C3K switch
must be powered off before removing the C3K‐2XFP IOM.
To remove the C3K‐2XFP IOM from your C3K switch:
1. Power off your C3K switch.
2. Disconnect cabling and XFPs from the module.
3. Loosen the two captive screws on the front of the C3K‐2XFP IOM.
4. Using the C3K‐2XFP's handle, gently remove the C3K‐2XFP IOM from your C3K switch.
5. If storing your C3K‐2XFP IOM, insert the C3K‐2XFP into antistatic packaging.
6. Return the coverplate to the expansion slot and tighten the captive screws.
2-4 Hardware Installation
Install the C3K-2XFP IOM