Installing an Optional Ethernet Expansion Module
3.4
INSTALLING AN OPTIONAL ETHERNET EXPANSION MODULE
NOTE: Install any optional equipment before proceeding to
CAUTION: An antistatic wrist strap is required to perform the following procedures to
minimize ESD damage to the devices involved.
Installing an Ethernet expansion module involves the following:
•
Removing the Front Panel Coverplate
•
Installing the Ethernet Expansion Module
•
Installing GBICs
1G-2GBIC or 1G-2MGBIC was installed.
3.4.1
Removing the Front Panel Coverplate
Refer to
Figure 3-1
NOTE: Unless noted otherwise, the following instructions apply to both the 1H582-25
and 1H582-51.
1. Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).
2. Place the device
3. Loosen the two captive screws
4. Remove the coverplate
3-4
Hardware Installation
(Section
3.5) or Mini-GBICs
and proceed as follows:
on an antistatic pad (not shown) on a sturdy flat surface.
until the coverplate
from the front panel. Save the coverplate for future use if necessary.
(Section
3.4.1)
(Section
3.4.2)
(Section
3.6). This is dependent on if a
is released from the front panel
Section
3.7.
.