Table of Contents
Advertisement
2 Getting started
2.1 Hardware installation
The V-Tap Analog is easy to setup. The following steps are involved:
•
Connect the phone to the V-Tap Analog (see below & next page).
•
Insert an SD card (up to 32 GB, FAT32 formatted).
•
Connect the local network. Not needed when Wi-Fi is used.
•
Connect USB to the V-Tap for power.
•
Access the settings in the web interface by using a browser.
The two possible ways to connect the V-Tap Analog to the telephone
system (line or handset) are shown in the next two schemes.
The possibility to use the V-Tap Analog for audio recording is shown in
the third scheme.
V-Tap Analog 2 Manual EN v4.21 Sept 2021 © 2018-2021 Vidicode
5
Advertisement
Table of Contents
Need help?
Do you have a question about the V-Tap and is the answer not in the manual?
Questions and answers