Notification & System Messages - Vidicode V-Tap Manual

7 Notification & System Messages
The following audio files are used by the system:
NOTIFY.WAV
SBEEP.WAV
NBEEP.WAV
BEEPS.WAV
Format of the messages:
G.711 A-Law, 8 KHz sample rate, Mono.
Other sample rates:
When the sample rate for recording is set to 16 KHz or 32 KHz, then
"16" or "32" must be added to the file name (so "NOTIFY16.WAV") and
the format of the message must also be accordingly.
Putting the messages onto the system:
1. With an SD card:
Put your .WAV file(s) in the root of an SD card.
Insert the SD card into the V-Tap. The system will automatically copy
the file(s) to its internal memory and delete the file(s) from the card.
Then the system reboots and the new messages are used.
2. With FTP:
Connect to the V-Tap with FTP and upload your .WAV file(s).
V-Tap Analog 2 Manual EN v4.21 Sept 2021 © 2018-2021 Vidicode
: The Notification message. This file is played by the
system when the notification is enabled and a
recording starts. The message usually says something
like: "Welcome.... this call will be recorded...".
This message is also played when a recording is started
by pressing the button.
: Stop beep or message. This file is played when a
Recording is stopped by pressing the button.
: Notification beep. Used when
the Special Settings &
heard by both parties during the whole conversation.
: System error beeps. This file is played by the system
when something is wrong, for example when no SD
card is inserted.
".IB<sec>"
Commands. A short beep is
is entered in
45