Overview of DFE-Platinum Module Shutdown Procedure
Overview of DFE-Platinum Module Shutdown Procedure
The DFE module
interdependent and operate under a single IP address as a single, distributed switch system
(hardware, databases, and persistent storage). In this operating environment, the DFE module
must shut down in an orderly fashion to ensure that the other modules in the system and other
devices on the network are notified of the impending change. The devices can then make
intelligent decisions and stabilize the network before the change is made; thereby increasing
network availability.
You can shut down a DFE module in an operating system using the
in Figure
•
"Recommended Shutdown Procedure Using OFFLINE/RESET Switch" (page 4‐7)
•
"Last Resort Shutdown Procedure Using OFFLINE/RESET Switch" (page 4‐7)
Figure 4-2
1 OFFLINE/RESET switch (in similar location on all DFE modules)
4-6 Troubleshooting
Caution: Do not remove a DFE module from an operating chassis system before reading the
following information and instructions.
Precaución: Antes de retirar los módulos DFE del chasis en funcionamiento, lea las siguientes
instrucciones y la información suministrada.
s
installed in a Matrix E7, Matrix N3, Matrix N5, or Matrix N7 chassis are
4‐2. There are two procedures to shut down a DFE module.
OFFLINE/RESET Switch
OFFLINE/RESET switch
À
shown