Using the Reset Switch
Using the Reset Switch
If you forget the SecureStack A2 login password, use the Reset switch as described in the
following procedure.
Figure 4-2
1 Reset switch
To reset the SecureStack A2 password, refer to Figure
1.
Press‐and‐hold the Reset switch while the switch is operational. This change of the
login password to the default password will be indicated via CLI only.
2.
Logon to switch management. You can now logon to the switch via the Console port
and assign a new password using the command line interface (CLI).
3.
To access switch management from your local PC, terminal, or modem connection,
refer to the SecureStack A2 Configuration Guide for instructions on how to log in and
enter a new password. The guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described
in "Getting Help" on page xviii.
4-8 Troubleshooting
Reset Switch
Note: Notify the system manager before changing the password.
À
4‐2 and proceed as follows: