Memory Locations and Replacement Procedures
Figure B-2
1 DRAM SIMM
DRAM SIMM Replacement Procedure
To remove and replace the DRAM SIMM on the 7H4382‐25, refer to Figure
Figure
Removing the DRAM SIMM
1.
If there is an optional NEM installed on the main board of the 7H4382‐25, proceed to
step 1a. Otherwise proceed to step 2.
a.
B-4 Mode Switch Bank Settings and Optional Installations
DIMM and DRAM SIMM Locations
2 DIMM
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
B‐4 respectively, and proceed as follows:
Note: Prior to removing the DRAM SIMM in a 7H4382-25, you must remove the network
expansion module (NEM) to gain access to the DRAM SIMM memory and connector.
Remove and save the three screws attaching the NEM to the front panel and to the
standoff on the main PC board.
3 Main PC board
Â
Á
À
B‐3 and