Memory Locations and Replacement Procedures
Figure B-6
1 Connector arms
3.
Rotate the DIMM upwards, then remove it from the connector fingers.
Installing the DIMM
To install a DIMM, refer to Figure
1.
Insert the DIMM down between the connector fingers.
2.
Pivot the DIMM downward so the tabs on the connector arms align with the two
DIMM alignment notches. With the two connector arms spread outward, push the
DIMM down between the connector arms. Then release the two connector arms to
lock the DIMM into place.
B-8 Mode Switch Bank Settings and Optional Installations
Removing the Existing DIMM
À
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Â
2 DIMM
B‐7 and proceed as follows:
Á
À
3
Connector fingers