Before installing the 7H4382‐25 DFE module, review the requirements and specifications
referred to in this chapter concerning the following:
For information about...
Link Aggregation
Module Placement in a Matrix E7 Chassis
FTM Bridge Function and Network Expansion Module
10BASE-T Network
100BASE-TX Network
The network installation must meet the requirements to ensure satisfactory performance
of this equipment. Failure to do so will produce poor network performance.
Link Aggregation
Link Aggregation is a method of grouping multiple physical ports on a network device
into one logical link according to the IEEE 802.3ad‐2002 standard. Because Link
Aggregation is standards based, it allows for automatic configuration with manual
overrides (if applicable), and can operate on 10 Mbps, 100 Mbps, or 1000 Mbps Ethernet
full duplex ports. Thus the network administrator can combine a group of five 100 Mbps
ports into a logical link (trunk) that functions as a single 500 Mbps port. As long as the
DFE‐Platinum modules agree on which ports are in the trunk, there are no problems with
looping, and the Spanning Tree can treat this trunk as a single port.
In normal usage (and typical implementations) there is no need to enable/disable ports for
Link Aggregation. The default values will result in the maximum number of aggregations
possible. If the switch is placed in a configuration with its peers not running the protocol,
Note: The Enterasys Matrix DFE-Platinum Series Configuration Guide and the Cabling
Guide referred to in the following sections can be found on the Enterasys Networks World
Wide Web site:
http://www.enterasys.com/support/manuals
Refer to
"Related
Documents" in
Network Requirements
About This
Guide.
DFE-Platinum Series Hardware Installation Guide 2-1
2
Refer to page...
2-2
2-2
2-2
2-2
2-2