Lanview Leds - Enterasys Matrix 7H4382-25 Hardware Installation Manual

Using LANVIEW
To view the receive and transmit activity on a group of attached segments, press the
GROUP SELECT button (see Figure
4). Each time the GROUP SELECT button is pressed, the GROUP LED lights up in
sequence, indicating which group is selected. The receive and transmit activity for that
group of segments is then indicated by the RX and TX LEDs for each port.
Figure 4-1 LANVIEW LEDs
1 MGMT LED
Table
appropriate.
4-2 Troubleshooting
4‐2 describes the LED indications and provides recommended actions as
Note: The terms used in
Flashing indicates an LED is flashing randomly.
Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid indicates a steady LED light. No pulsing.
Alternating indicates an LED is flashing at a steady rate other than 50% on, 50% off.
4‐1) to step to the group of interest (Groups 1 through
À
2 Group 1, Port 1 LEDs
Table 4-2 indicate the following:
Á